usb 2-5: new high speed USB device using ehci_hcd and address 4
usb 2-5: configuration #1 chosen from 1 choice
firmware: requesting v4l-pvrusb2-29xxx-01.fw
usb 2-5: New USB device found, idVendor=2040, idProduct=2900
usb 2-5: New USB device strings: Mfr=0, Product=0, SerialNumber=0
pvrusb2: Device microcontroller firmware (re)loaded; it should now reset and reconnect.
usb 2-5: USB disconnect, address 4
pvrusb2: Device being rendered inoperable
usb 2-5: new high speed USB device using ehci_hcd and address 5
usb 2-5: configuration #1 chosen from 1 choice
usb 2-5: New USB device found, idVendor=2040, idProduct=2900
usb 2-5: New USB device strings: Mfr=1, Product=2, SerialNumber=0
usb 2-5: Product: USB Device
usb 2-5: Manufacturer: Hauppauge
usb 2-5: reset high speed USB device using ehci_hcd and address 5
msp3400' 1-0040: MSP3415G-B8 found @ 0x80 (pvrusb2_a)
msp3400' 1-0040: msp3400 supports nicam and radio, mode is autodetect and autoselect
saa7115' 1-0021: saa7115 found (1f7115d0e100000) @ 0x42 (pvrusb2_a)
tuner' 1-0061: chip found @ 0xc2 (pvrusb2_a)
tveeprom 1-0050: Hauppauge model 29034, rev C347, serial# 6510162
tveeprom 1-0050: tuner model is LG TP18PSB01D (idx 47, type 28)
tveeprom 1-0050: TV standards PAL(B/G) (eeprom 0x04)
tveeprom 1-0050: audio processor is MSP3415 (idx 6)
tveeprom 1-0050: decoder processor is SAA7115 (idx 19)
tveeprom 1-0050: has radio, has IR receiver, has no IR transmitter
pvrusb2: Supported video standard(s) reported available in hardware: PAL-B/B1/G/H;SECAM-B/G/H
pvrusb2: Mapping standards mask=0xd000f (PAL-B/B1/G/H;SECAM-B/G/H)
pvrusb2: Setting up 9 unique standard(s)
pvrusb2: Set up standard idx=0 name=PAL-B/G
pvrusb2: Set up standard idx=1 name=SECAM-B/G
pvrusb2: Set up standard idx=2 name=PAL-B
pvrusb2: Set up standard idx=3 name=PAL-B1
pvrusb2: Set up standard idx=4 name=PAL-G
pvrusb2: Set up standard idx=5 name=PAL-H
pvrusb2: Set up standard idx=6 name=SECAM-B
pvrusb2: Set up standard idx=7 name=SECAM-G
pvrusb2: Set up standard idx=8 name=SECAM-H
pvrusb2: Initial video standard guessed as PAL-B/B1/G
pvrusb2: Device initialization completed successfully.
pvrusb2: registered device video1 [mpeg]
pvrusb2: registered device radio0 [mpeg]
tuner-simple 1-0061: creating new instance
tuner-simple 1-0061: type set to 28 (LG PAL_BG+FM (TPI8PSB01D))
msp3400' 1-0040: msp3400 rev1 = 0x0207 rev2 = 0x0f48
msp3400' 1-0040: Audio:    volume 62000
msp3400' 1-0040: Audio:    balance 0 bass 0 treble 0 loudness off
msp3400' 1-0040: Standard: autodetect start (mono)
msp3400' 1-0040: Audmode:  0x0001
msp3400' 1-0040: Routing:  0x00000000 (input) 0x00000044 (output)
msp3400' 1-0040: ACB:      0x0c00
saa7115' 1-0021: Audio frequency: 48000 Hz
saa7115' 1-0021: Input:           Composite 4
saa7115' 1-0021: Video signal:    bad
saa7115' 1-0021: Frequency:       50 Hz
saa7115' 1-0021: Detected format: BW/No color
saa7115' 1-0021: Width, Height:   720, 480
tuner' 1-0061: Tuner mode:      analog TV
tuner' 1-0061: Frequency:       175.25 MHz
tuner' 1-0061: Standard:        0x00000007
firmware: requesting v4l-cx2341x-enc.fw